|
Farmall & IHC Tractors Discussion Board |
Re: when is it time to change the front spindels?.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on November 13, 2003 at 05:25:48 from (209.226.247.104):
In Reply to: when is it time to change the front spindels?. posted by Jonathan on November 12, 2003 at 14:17:58:
Jonathan: I have seen spindles break on tractors less than 1 year old. I have also seen tractors 50 years old that heve never broken a spindle. I've seen 40 year old tractors that always had a loader and never broke a spindle. I personally only ever broke one of them, and that tractor never had a loader on it. My 1066 broke a spindle at about two years of age. Tractors the 100 plus hp range, with duals on, and doing heavy tillage work, will put a lot of stress on front axle. Having said all of this, the single biggest cause of front end breakage on tractors is the nut behind the wheel. That was the case with my 1066, and the nut was so advised. I personally would never put a loader on a farm tractor, they weren't designed for it. Fine if you just want to do a bit of yard work, move bit of earth, etc. If however you are into high production farming with loader going full out most of day. Go and buy a real loader, it will be a lot more economical in the long run. In the 1970s I needed loaders at to separate farms. I already owned a Farmall 560D with 2000 loader. I went out and purchased a 45 hp skid steer loader. That machine would load circles around the 560. Two years later I bought a second skid steer loader. Within 2 months my 2000 loader was taken off the 560, packed away in the drive shed until 10 years later a guy came along and bought it. In 1972 those skid steers could be bought for 30% of the cost of a new 65 hp tractor and loader. I imagion the same is still true. Yes I did handle 1200 lb. round bales. Every loader job on my farm, one of those 45 hp skid steers could out perform 560 and 2000 loader hands dowm.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
