Farmall & IHC Tractors Discussion Board |
Re: 4000+ hrs on gas engine, how much longer will
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Allan on November 17, 2003 at 03:18:39 from (148.63.132.164):
In Reply to: 4000+ hrs on gas engine, how much longer will it h posted by Gramps544 on November 16, 2003 at 16:46:15:
Hi Gramps, Engines are funny things and don't follow the rules as they are written down or as we think of them & how they wear. :>) After a gasoline engine is brought up to tempreature, for all intents and purposes, there is no wear whatsoever. The wear comes when it is started cold and also if it is allowed to idle for long periods of time. These are the times when the upper cylinder walls are least likely to get lubrication. That's why most of these old tractors were designed with updraft fuel systems. They are designed to keep that fuel to a minimum while the choke is being used and the engine is cold. Raw fuel washes lube away from that cold cylinder wall. So, you can see that you really cannot compare engines in cars with engines in a tractor. You would never want to buy a used car where it's previous owner "Was a little old lady who just drove the car down to the post office and to church". That car has had a terrible life. Car engines are abused in the worst possible way plus the fact that they are allowed to rev much, much higher than your tractor's engine. You never hear of a car's engine lasting for over 50 years, but there are many tractors out there which have worked hard all their life and are still going strong. I would venture that many of these old tractors have upwards of 10,000 hard working hours on them. So, if your tractor's engine is running fine, not making any unusual noises and not using oil, I would not even worry about it. Just ignore that hour meter and keep on keepin' on. Allan
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|