|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: WD 6 plugs
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark on December 13, 2003 at 08:12:52 from (209.162.160.30):
In Reply to: Re: Re: WD 6 plugs posted by Haas on December 13, 2003 at 06:24:25:
For the sake of 4 nuts and a hose clamp, in the past I have just always removed the intake manifold to avoid breaking plugs. Also when i remove the carb for cleaning I always pull the manifold, carb nuts are immpossible to get at too. Not very bright ideas at ih in a time when tractors were suppossed to be almost totally operator serviceable, could you imagine trying to get to work in the fields in the late 40's, early 50's and break a spark plug or two trying to get them out to clean them??? might be a half day trip just to get to town. Bet there has been alot of cussing over the years. not many deep or swivel sockets back then.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
