Farmall & IHC Tractors Discussion Board |
Farmall C, Blown head gasket and coolant problem
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Greg Ziegler on December 17, 2003 at 08:31:30 from (67.73.163.29):
I recently acquired a farmall C and it blew a head gasket. It started puffing exhaust out the side between the block and the head. Before this however, when I changed the oil for the first time I noticed coolant in the engine oil.I started to drain the coolant but no coolant would come out. I only can get a little oily sludge on the end of a wire I stuck up the drain tube in attemping to unplug it. I took off the head anyway and after I cleaned up my mess I noticed a break in the gasket around one of the head bolts. I see no way that coolant could get into the oil with where this break was. I have two main questions. What is the best way to deal with a sludge plugged coolant system,and what is the most important things to do to prep the head, and all components to put it all back together.I never did this before and also do not know what other problems could exhist that could allow coolant into the oil. The tractor still ran great when I decided it should not be ran any longer. Someone's help would sure be great! Thanks, Greg Ziegler
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|