Re: hydraulic cylinder on 27V sickle bar mower

Posted by randy hall on December 21, 2003 at 20:59:17 from (209.11.237.78):

In Reply to: hydraulic cylinder on 27V sickle bar mower posted by Jon on December 21, 2003 at 16:17:00:

the factory setup uses a long rod back to the mower lift pivot shaft up to the tractor with a lift all cylinder hooked to the drawbar clamp, this piece may have to be turned so the long end with the hole in it points down to hook the back of the cylinder to, then there is another piece that bolts to the boss on the side of the transmission that the long rod and the front of the cylinder pivots off of.this is the setup for putting your mower on a h or an m. it would be easier to buy a manual for your mower on ebay if you have never seen this before or you could rig up some brackets to use a standard 3" by 8" cylinder.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: hydraulic cylinder on 27V sickle bar mower Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]