|
Farmall & IHC Tractors Discussion Board |
Re: Re: Hard to find Hydraulic experts
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BlueLite on December 28, 2003 at 08:07:36 from (209.226.181.65):
In Reply to: Re: Hard to find Hydraulic experts posted by Mark in AB on December 27, 2003 at 10:32:30:
The position control lever is full down, and it seems like the position is being ignored altogeather. Funny thing is, when it reaches the top, you would think the pressure release valve would start kicking in evidence the pump would be under load and the engine slowing, but that doesn't happen. When I turn off the engine the arms go down. The draft lever is full forward or down, and of course the isolator valve is open, and the fast/slow valve is on fast. My hunch is it's in the linkage somewhere. Well, one plus about this tractor is that it has 2 access holes to work in, so I guess it's going to be me to do the work and I'll have to chok up this bad dream to experience. Think I'll get that manual.
Follow Ups:
Home
| Forums
Today's Featured Article -
Product Review: Kreem Brand Fuel Tank Liner - by Staff. This condition has occurred on a few machines that we have had and fortunately we were able to borrow the technique used at the local motorcycle shop. The product that we have used is called Kreem thouh there are others on the market, this one was recommended and available. This particular product is sold in three parts, a bottle of etch, dryer, and sealer. We were fortunate enough to start the process with stern warnings from those that had used this type of product before. The horror
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
