Farmall & IHC Tractors Discussion Board |
Re: DT466 in a 856
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by E J on January 02, 2004 at 13:01:34 from (67.31.156.16):
In Reply to: DT466 in a 856 posted by KP, INDIANA on January 02, 2004 at 09:14:21:
Theirs a few of us in western Iowa have put them in.Two way's to do it.Use 66 side rails &motor plate on rear,need to make cross over pipe on bottom rad.hose ,longer hood I used 560 hood cut to fit. Also change throtle linkage to left side,fuel lines too .Air filter rigt side inlet for turboed engine.Flywheel&clutch off 1066.On mine wanted it to look more stock used old frame rails and lenghend the them narrowed the front motor plate on the 466 engineto fit the narrower 56 frame bored new holes in 56 frame for front motor plate bolts.It's doable.
Follow Ups:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Variable pulley for case 1530 skid loader
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|