|
Farmall & IHC Tractors Discussion Board |
Re: MW hub info - need help please
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by mikeinmo on January 22, 2004 at 19:10:19 from (208.31.189.216):
In Reply to: MW hub info - need help please posted by Doug on January 22, 2004 at 16:36:09:
Dug out some literature I had from M&W dated Feb. 20,1989. The numbers you have listed are not listed as current items in this brochure. However looking back in the repair parts section I found the following: 80E15 >> G1000 Minni-Mo with 3-15/16" axle
80E9 >> AC 190XT,D21,200,7000 with 3-1/4" axle
60E35 >> Oliver Super 88,880,1600,1650 with 2-7/8" axle
60E43 >> AC D19,190,190XT with 2-3/4" axle Hope this helps. Pretty sure this is accurate information.
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
