Farmall & IHC Tractors Discussion Board |
Re: Re: Re: super A tappet adjustment
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by mikeinWA on February 05, 2004 at 11:18:29 from (209.206.241.122):
In Reply to: Re: Re: super A tappet adjustment posted by Hugh MacKay on February 05, 2004 at 10:31:03:
Hugh- You should have seen me in the shop last night argueing with myself about how to proceed. I too have always set solid rod lifters by watching rockers or cam followers but was so anxious to use my new manuals that I just wouldn't rest until I had it figured to spec. Maybe that part of the manual will end up out in the brush next to the timing light. (I've also always favored timing by ear, or how 'bout the trick of setting a glass of water on the hood to get the smoothest idle)I'm still not sure whether I've found the right mark, little things like this can really drive a fella mad when theres enough tome to fret over them.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|