Farmall & IHC Tractors Discussion Board |
Re: Front or rear blade on Farmall 100
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Randy in NE on February 11, 2004 at 11:01:29 from (216.58.237.20):
In Reply to: Front or rear blade on Farmall 100 posted by Paul in Mich on February 11, 2004 at 10:20:05:
The front blade is going to be easier to use. It will cause the back end of the tractor to be a little light so you may need either chains or wheel weights, or both. With the back blade you will either be driving over and packing the snow if you pull it forward or you are going to be swiveling around on the seat trying to watch where you are going as you back up if you are pushing it with the blade turned around. Did it as a kid and it got old as a teenager. Now that I am older I don't think that my back and neck would like that very much.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|