|
Farmall & IHC Tractors Discussion Board |
Re: Re: Farmall H bore/ belt pulley ?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farm w/Junk on February 15, 2004 at 08:11:38 from (157.134.184.150):
In Reply to: Re: Farmall H bore/ belt pulley ? posted by Rod on February 14, 2004 at 19:00:53:
Hi thanks for replying. I have it torn apart, getting my head checked and cleaned and decked, got new rod bearings, and was going to hone the sleeves and change the rings. Well I ordered the rings and the ones he sent said standard but they are just a hair bigger then my pistons but are thinner. So I was trying to figure out what was stock. I have to pull the whole pulley assembly off? I guess it wont be too hard since the tractor is striped. Here are some pictures of my tractor.
First pic:
http://www.tractorshed.com/cgi-bin/gallery/photo_pic.cgi?pic=http;//www.tractorshed.com/gallery/tphotos/a20141.jpg&firstrec=1&lastrec=15&Parameter=1946%20Farmall%20H&mode=All&what=tphotos Second pic:
http://www.tractorshed.com/cgi-bin/gallery/photo_pic.cgi?pic=http;//www.tractorshed.com/gallery/tphotos/a20142.jpg&firstrec=1&lastrec=15&Parameter=1946%20Farmall%20H&mode=All&what=tphotos Third pic:
http://www.tractorshed.com/cgi-bin/gallery/photo_pic.cgi?pic=http;//www.tractorshed.com/gallery/tphotos/a20241.jpg&firstrec=1&lastrec=15&Parameter=1946%20Farmall%20H&mode=All&what=tphotos
Check them out. Thanks again for your reply.
Matt
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
