Farmall & IHC Tractors Discussion Board |
Re: Oil Soaked Clutch Disks
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by K C in Iowa on February 20, 2004 at 12:07:53 from (67.2.241.48):
In Reply to: Oil Soaked Clutch Disks posted by BlueLite on February 20, 2004 at 06:26:15:
Clean organic clutch disc in parts cleaning solvent or can use acetone type paint thinner(be careful of sparks or flame). IF you have access to oil absorbant floor dry, put disc in it and let sit for at least 8-10 hours, if not let air dry for a day.. Then install, I know the books say not to but!, why not try to reuse.. As for heating the fly-wheel ring, that expands it so it will almost slip on over the flywheel, and when cool will stay in place.. Heat it evenly or you may risk removing some of the temper from the steel.. Have done both of these operations many times.. goog luck..
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|