Re: Governor C-113

Posted by scotty on February 25, 2004 at 12:10:03 from (199.231.49.128):

In Reply to: Governor C-113 posted by Shaggy on February 25, 2004 at 11:02:29:

Shaggy,
When I tore my govenor apart on my Super A I found the slop on that shaft was a combination of the hole in the cast housing wearing and the shaft was also warn. What I did was make a new shaft and the Z bent lever, getting a nice fit between the shaft and the housing. Some guys have also bored the govenor housing out and pressed in a bushing. While you have the govenor apart you may as well replace the felt seal pressed into the counterbore. Also, my thrust bearings were shot and need to be replaced. I havent done that yet because I got involved with another project. Hope this helps.

scotty

Follow Ups:

• Re: Re: Governor C-113 Shaggy 11:02:05 02/26/04 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Governor C-113 Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]