Farmall & IHC Tractors Discussion Board |
Re: Re: Oil Pressure Problem Relieved
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark on February 29, 2004 at 06:16:39 from (209.151.114.75):
In Reply to: Re: Oil Pressure Problem Relieved posted by Tommy H on February 28, 2004 at 18:49:11:
I think the lights are set so low that they are essentially useless as an indication instrument. By the time the light comes on, you need to head for the shop (for an overhaul). I think manufacturers do that so people aren't in the dealership all the time with blinking lights, being Detroit likes to recommend 5W-30 (to meet govt. mileage requirements)and that stuff sucks when it's even warm outside. I have compared lighted engines (tractors and cars/trucks) to presure gauges on the same engine (I installed for troubleshooting). On the equipment I was measuring the pressure could get down to 10psig before the light would come on. This is especially important on cars with high volume low pressure systems, which I think my Tahoe has. It has a gauge, and if you put 5 or 10w-30 in it and turn on the ac and run 5 miles down the interstate in the summer, then let it idle, the oil pressure is less than 20 psig. But if I put OIL,REAL OIL (15w-40 truck oil) in it it will hold 30 whereas it was at 50 when cranked....new truck. Now my Dodge is a different story. That sucker is 6 years old and holds 60 psig of oil pressure regardless....only time it moves off 60 is when the ignition key is off and during the first few seconds when first started. Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|