Re: Help! A sleeve installing emergency! Arrrrrr

Posted by Zak on March 13, 2004 at 15:11:13 from (64.12.97.12):

In Reply to: Help! A sleeve installing emergency! Arrrrrr! posted by Zak on March 12, 2004 at 12:35:38:

The sleeve set was from Weber's (a good supplier I might add) and is made by Gould. The tractor/engine is a 300 gas. Stock sleeves were 3 9/16", new ones are 3 5/8". When I tried to replace one of the old sleeves in the block, it was just as tight as a new one, so I think I'm ok there. I'll try marking a sleeve with a pen and then driving it and checking for movement. If this doesn't work, I can try the reverse puller setup as suggested. I'll keep ya posted! Zak

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Help! A sleeve installing emergency! Arrrrrr Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]