560 TA ? need advise

Posted by joe on April 10, 2004 at 16:26:00 from (205.146.39.78):

The Torque Amplifier only works in low range (lever back). I checked all the adjustments and removed the cover on top of the T A clutch to observe the clutch engagement. It engages just fine, there is space between the fingers and the throw-out bearing, but the clutch slips, so I have no direct drive. I just had the tractor split and thought the clutch and pressure plate was OK, but it doesn't seem to apply much force to the clutch disk. And yes, I did remove the 3- 5/16-18 cap screws when I had the clutch and pressure plate off. I suppose I will have to split the tractor again, but I don't want to take the center clutch housing off. When I had it apart before the torque amplifier assembly would only turn in one direction. I thought it was because of the rollers running up on the ramp, or am I wrong? Is there anything I can check without completely removing the TA? The tractor runs fine other than no direct drive. Any advise would be appreciated.

Follow Ups:

• Re: 560 TA ? need advise RickB 16:37:27 04/10/04 (1)
  • Re: Re: 560 TA ? need advise joe 16:50:45 04/10/04 (0)

Post a Followup Name: E-Mail: Subject: Re: 560 TA ? need advise Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]