Farmall & IHC Tractors Discussion Board |
Farmall M Manifold Questions
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by thert on April 19, 2004 at 07:36:14 from (65.19.206.86):
Will a H manifold fit on an M? Here is the situation: I have a small crack in the intake side of my M's manifold near #3 cylinder intake just after the square portion of the manifold. Problems are: I can't get #3 to fire and have replaced plug and have spark (maybe a wee bit weak), new #3 plug is wet no firing indicated at all, tractor starts easily and runs but need to run on nearly full choke, #4 cylinder was not hitting so I replace plug and it fixed problem but I noticed that I had carbon build up very soon after (running to rich?), can't seem to get much adjustment from the high or low speed screws on carb (both in all way then back out 1 1/2 - 2 turns), carb was dismantled and socked in cleaner for a day, did a quick compression test before I bought the tractor and thought all cylinders were near 100 psi (I will run another check soon to verify variation b/w cylinders). Do you think that the crack is responsible for all the problems or could there be other problems (carborator? or ignition?) that I should check first? Thanks Tim
Follow Ups:
Home
| Forums
Today's Featured Article -
The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|