Farmall & IHC Tractors Discussion Board |
Re: Re: Straighten Me Out
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Joe Evans on May 14, 2004 at 07:34:20 from (209.41.233.196):
In Reply to: Re: Straighten Me Out posted by Hugh MacKay on May 13, 2004 at 14:29:30:
Hugh: the MAXIMUM BRAKE HORSEPOWER test lasted two hours. That is, indeed, and endurance test! During this period (as you probably know) fuel economy figures were recorded. There were some tractors that broke during this test, but the vast majority did fine--a testimonial to engineering. Little wonder that it is not unusual for tractors to accumulate tens of thousands of hours of use before major rebuilds. I believe the MAXIMUM DRAWBAR HP test also lasted for two hours. There was also a 10 hour marathon drawbar test where (I think) this was done at 75% maximum pull. This test was done for reliability review and also fuel economy. I'm likely a bit fuzzy on the test parameters. C.H. Wendel has a good section on the test parameters in his book "Nebraska Tractor Tests Since 1920". Quite fascinating reading, and it illustrates how in-depth Nebraska wanted to get with respect to data.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|