Farmall & IHC Tractors Discussion Board |
Re: OT- Moving Rocks
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on May 19, 2004 at 13:35:46 from (165.170.128.66):
In Reply to: OT- Moving Rocks posted by scotty on May 19, 2004 at 06:29:00:
Scotty - For moving large rocks any distance this works nice: Take a piece of corrugated iron (roofing/siding) at least half again as long/wide as your biggest stone. (An old car hood, refrigerator door, or similar metal scrap will work too). Bolt a 4x4 the width of the metal across one end of the metal. Attach with ˝” wood lags or carriage bolts, and use washers under the heads. Finally punch a hole - centered and where the rear face of the 4x4 meets the metal - thru the metal big enough for a log chain grab hook to pass through. To move a rock: Position your “skid” next to the rock and oriented so your tractor can be hooked to the end with the 4x4. Use your FEL to roll the rock onto the skid so it’s more or less centered on the metal. Now run a log chain around the 4x4 then thru the punched hole and hook it back onto itself. Then hook the free end of the chain to the tractor drawbar. The shorter the chain between the drawbar and skid the better – you want it to lift the front of the skid a bit as the tractor pulls. You can now skid the rock easily wherever you want it. This works best in tall weeds, on wet grass etc. and will hardly leave a mark. But it also works fine on tilled soil or hard ground – the metal will just wear out faster. I've used it to move rocks in excess of 1,000 lb with ease. Have fun, and work safe!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|