|
Farmall & IHC Tractors Discussion Board |
560 hydraulic control
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by greg on May 21, 2004 at 15:37:09 from (216.215.132.160):
I bought a 560 d a while back that was missing the hyd. cylindar on the fast hitch. I found one and put it on the tractor. Now I can't understand how to get the control lever to work it properly. It has two levers on the right side of the dash. The inside lever seems to work the remote cyl. and is working good. The outside lever seems to work the ram for the fast hitch along with some kind of rod that runs along the left side of the floor to the rear of the tractor,it is not hooked to any thing on the rear, but goes to a linkage to the control valve.If I move this rod back and forth the ram will go up and down I can hold it in a certain place and the hand lever on the dash will work the ram but it doesn't want to stay in hold position it either tries to go up or down. Thanks for any help.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
