Re: TA question

Posted by Kelly C on May 23, 2004 at 21:19:25 from (63.171.43.140):

In Reply to: TA question posted by riverbend on May 23, 2004 at 20:26:58:

Most times its the ramp and roller set up that fails. Free wheeling in TA mode or shifting the TA to try and slow down. Usually does them in.
The TA is to be used to shift to a lower gear when the engine bogs down. Not to slow the tractor when its over reving from going to fast.
ALso engine back fires that get it turning in the oposite direction on a untuned engine can hurt them.( My 400 does this and I hold the clutch in untill it stops. Its hard on the PTO also.)
I suspect that the planitary gear set fails some times but not near as offten as the Ramp and rollers.
Clutch can wear out also.

Follow Ups:

• Re: Re: TA question Wardner 22:23:39 05/23/04 (1)
  • Re: Re: Re: TA question Kelly C 22:12:49 05/24/04 (0)

Post a Followup Name: E-Mail: Subject: Re: Re: TA question Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]