|
Farmall & IHC Tractors Discussion Board |
Re: Re: International Cub Belly Mower
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Buck Cole on May 31, 2004 at 09:32:15 from (68.97.146.39):
In Reply to: Re: International Cub Belly Mower posted by 49 Cubber! on May 31, 2004 at 06:42:22:
That is what I'm wondering about mine. The pulley is held on with a cap with a 9/16" bolt that goes down through it into threads in the shaft and tightens the cap on. There is a locating pin (almost a bump) that is on the bottom of the cap that fits into a square slot in the shaft but I cannot see a pin that is in down in the square slot. That is where I was wondering if a shear pin was but I just couldn't see it due to grease. Is this where the insert you are talking about goes? There are 2 nuts (I think 1/2 "). I think they are on the part with 4 tapered (wedge shaped) slots that the spring loaded pins on the bottom of the pulley go down into to engage the pulley to the shaft assembly. One of those was loose so I tightened it lightly. The bolt that those two nuts go over looks hollow, almost like a tube with threads on the outside. The pins on the pulley engage just fine with that "slotted" part. The slotted part turns with the pulley but the shaft that goes through all of that doesn't turn with it. I don't know if this could be part of the problem or not. Sorry for the long response. I really appreciate your help. Buck
Follow Ups:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
