Farmall & IHC Tractors Discussion Board |
SA cultivator set up
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by mikeinWA on June 01, 2004 at 12:43:37 from (69.29.192.40):
OK- I am at the stage where I have narrowed my wheel spacing decisions down to two options. One will maximize the distance between the wheels, and though I have already asked this question I hope you all will forgive me for asking again. Will I risk damage to the final drive housings when I space the rear wheels on 68" centers. The machine will look like a spider and I am concerned about the increased stress on these parts (final drives, bearings etc). Also please advise on the distance from the outside row of plants to the inside of the tire, that is to say ; What is a safe distance between them to insure I do not compact the soil or damage plants. I have figured on about 9". I do not intend to cultivate very large plants, 12" or so max. Thanks so much for the help!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|