Farmall & IHC Tractors Discussion Board |
Re: 1938 F12
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Zak on June 02, 2004 at 10:48:25 from (128.175.85.99):
In Reply to: 1938 F12 posted by Amos on June 01, 2004 at 19:14:20:
I did my 34' F-12 at 75 lbs and she leaked. What I learned the hard way is this. Put a very thin bead of permatex gold (or similar) around each of the water passages in your head gasket, both sides of the gasket. Then place your gasket on the block, followed by the head. You'll want to torque the head down in three seperate sessions. Final torque to 95 ft/lbs. I did mine at 55, 75, and finally 95 ft/lbs. Run it for about 10 hours worth, then recheck your bolts. They should be tight, but it's easy enought to check and a pain to replace the gasket so you're better safe than sorry. Good luck. Zak
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|