Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: Re: Re: Super
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on June 06, 2004 at 19:20:15 from (64.228.12.158):
In Reply to: Re: Re: Re: Re: Re: Re: Re: Super posted by CNKS on June 06, 2004 at 11:16:21:
CNKS: I have operated a Super H some and aside from TA and IPTO, really quite hard to pick out much differences both in speeds and power. I suspect the transmissions (5 speeds) are the same. I have done a lot of varried work with 300 as that tractor was around our farm close to 4 decades. Most of the work I would have done with that 51 H would have been tillage. About the only job I ever got to do with the W4 was wagon and hayloader. I was only 9 when dad traded that off for the H. The first time I ever disked with the 300 I said to my dad, " without TA that tractor wouldn't have much more wallop than the H." Dad who by then had done a lot more work with all three than I, said, "The big difference is between H and W4 not between H and 300." Dad was not the type of guy to put the tractor a gear higher just because it would pull it. His plowing all could have passed as competition plowing. The W4 and H, are quite close on hp specs, and there is more in common than engine. While the castings are different, I think you will find many similarities within. I'm thinking the ratios to the rear axle are exactly the same, and having a wider, smaller diameter rear tire, statistically should give the W4 advantage. After all that is what the standards were built for, pulling where traction was never a problem.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers WD45 (Gas Version) - by Staff. Beginning production in 1953, the WD45 had the same general look as the WD tractor which was produced earlier - but was much more powerful. This was due to the new 4-cylinder "Power Crater" gasoline engine with a 4 x 4-1/2 inch bore and stroke. Some people feel this was one of the most significant tractors offered by Allis-Chalmers in those days. Nothing in its weight or power class could match its performance. In 1954 they began offering the WD45 with the new "Snap-Coupler&quo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|