|
Farmall & IHC Tractors Discussion Board |
Re: IH 454 acting up again........
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JB on June 09, 2004 at 19:56:26 from (24.157.143.220):
In Reply to: IH 454 acting up again........ posted by Joe on June 09, 2004 at 09:41:53:
Hi, very interesting problem.. screeching stops when clutch is depressed..that would indicate the problem is somewhere from transmission drive shaft back thru transmission .. but you say when transmission is in neutral it screetches with clutch engaged. Does it screetch if you change the 1,2,3,4 shift lever to different gears ?
Does this tractor have TA? I know it was not common to have TA on 454 only on 574 and larger.
The transmission shaft runs inside the PTO shaft until behind bell housing and in front of transmission. This is where hydraulic driven PTO clutch pak is to engage/disengage rear PTO shaft.
The PTO shaft is splined to the pressure plate and turns all the time. Since screetching stops when clutch is depressed, my guess the problem is a bearing on main drive shaft on the input to the transmission. Good luck and please post solution when you fix it. JB
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
