Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: IH 2 disk breaking plow questions
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jimmy King on June 16, 2004 at 09:24:08 from (207.69.138.200):
In Reply to: Re: Re: Re: IH 2 disk breaking plow questions posted by Allan in NE on June 16, 2004 at 05:32:43:
Good question, a one way the disc are on a common shaft I don't know if they had scrapers when new or not, I have only seen them in pictures and in Ok and Ks. not here in the rocks of Southwest Mo, a 2,3, or 4 disc disc bottom plow the disc are individual units with scrapers and the scrapers are used to throw the dirt. When I was young disc bottom plows were all I had ever seen used around where I live because of the rocks, they gave way to auto reset bottom plows, offset plows, and belive it or not chiscel plows. The disc set at a straighter angle on a bottom disc plow than than a oneway does.
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|