Re: Nit-picking Details on a H

Posted by 26Red on June 18, 2004 at 10:40:45 from (170.92.1.104):

In Reply to: Nit-picking Details on a H posted by kfox on June 18, 2004 at 08:05:38:

You can go to you local autoparts store to get replacement studs. Or buy some threaded redi-rod and cut it to length(3 or 4 inches). I don't remember the thread size size off-hand(3/8-16?). To remove the old studs, get a bolt extractor kit. Drill the appropriate size hole in the stud, then screw in the extractor. A plumber's torch(propane torch) works well to heat up the broken stud- a little heat makes it unscrew a lot easier. Be carefull not to heat it up too much or you may melt the solder on the rad. joints..

Check with OEM tractor parts or your local case-IH dealer for the stud size.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Re: Re: Nit-picking Details on a H Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]