Farmall & IHC Tractors Discussion Board |
Re: 49' M fuel/timing question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan on June 24, 2004 at 07:30:40 from (12.160.171.192):
In Reply to: 49' M fuel/timing question posted by jamie on June 23, 2004 at 19:45:19:
I put an in line filter in the fuel line on my MSTA as it sat for some time outside and had rust in tank. As mentioned it really didn't help the rust in tank blocking sediment bowl inlet. I had trouble with it letting fuel through properly so that if it ran out of fuel in the carb I had to bleed the line to the carb beyond the filter to get fuel to flow. Not sure if I had the wrong type filter. I think I would go to straight 30 wt oil in the M but I wouldn't worry about a puff of smoke when starting. Probably oil that goes down valve guides when engine is stopped. Old timers felt it at least kept valves oiled and guides can be too tight.
Follow Ups:
Home
| Forums
Today's Featured Article -
A Belt Pulley? Really Doing Something? - by Chris Pratt. Belt Pulleys! Most of us conjure up a picture of a massive thresher with a wide belt lazily arching to a tractor 35 feet away throwing a cloud of dust, straw and grain, and while nostalgic, not too practical a method of using our tractors. While this may have been the bread and butter of the belt work in the past (since this is what made the money on many farms), the smaller tasks may have been and still can be its real claim to fame. The thresher would bring in the harvest (and income) once a y
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|