Re: IH 241 Baler Question

Posted by ny bill on July 14, 2004 at 18:26:30 from (66.24.196.252):

In Reply to: IH 241 Baler Question posted by Carp on July 14, 2004 at 17:09:24:

the book only gives a minimum length of 424" for the upper belts. it says that belts less than 424" must be lengthened. it also says to check belt length variation thus: raise the rear gate all the way open and measure the sag midpoint from the bottom roller on the gate, to a straight line to the roller above the front hold down roller (sag on the long exposed part of belt). if sag exceeds 8", mark these belts, close gate and adjust belt length as required affecting the least number of belts. an 8" sag indicates approx 5" of belt length difference.
btw, the 241 operator's manual is part # 1095094R1.

Follow Ups:

• Re: Re: IH 241 Baler Question Chris Brown 21:03:16 07/14/04 (0)

Post a Followup Name: E-Mail: Subject: Re: Re: IH 241 Baler Question Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]