Farmall & IHC Tractors Discussion Board |
Re: Re: Re: moisture content of dry hay
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on July 28, 2004 at 18:20:12 from (209.226.247.104):
In Reply to: Re: Re: moisture content of dry hay posted by Dave H (MI) on July 28, 2004 at 06:25:04:
Dave: We had a barn dryer. This unit was a 5hp electric unit with a 4' by 4' duct along one wall. Inside the duct were 8' long shutters to allow air out under a slated floor the hay was piled on. This enabled us to open 8' sections of the floor at a time as we filled the barn. As we progressed we could shutt the early sections off. What you had to achive with this unit was pack bales tight enough together so as not to allow free air to escape. We tried numerous ways of piling, finally settling on piling bales on their edge. At the end of each days filling we would go over the surface. You could feel the air coming up through hay. If we found an area with too much free air escaping, we would stuff loose down using a plunger affair made from a fork handle. We also bricked those bales both ways. It was a bit of a pain getting it started at the end of barn. Our aim was not to put wet hay in barn, but rather baling before hay got dry enough for leaf shattering in alfalfa. Most of that hay went in closer to 20% than 15% moisture. The dryer quickly took it to 15%
Follow Ups:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|