Farmall & IHC Tractors Discussion Board |
Re: valve ajustment W-4 or H
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Red on August 30, 2004 at 12:18:33 from (206.246.187.111):
In Reply to: valve ajustment W-4 or H posted by Bob Quale on August 30, 2004 at 11:45:11:
Make sure the cylinder that you are adjusting the valves is on compression stroke top dead center. I use a .018 feeler gauge for cold settings. The feeler gauge should be placed between the adjustable tappet and the end of the valve stem. Just loosen the locking nut and adjust the tappet with a screwdriver until the feeler gauge is just getting tight but still removable. Then lock down the locking nut while keeping a screwdriver in the tappet slot so it does not tighten on you.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|