Re: Regrind cam from IH

Posted by El Toro on September 21, 2004 at 14:38:44 from (170.224.224.154):

In Reply to: Regrind cam from IH posted by Shaggy on September 20, 2004 at 20:47:59:

Hi, I've never used a reground cam, but I used
a lot of reground crankshafts. Never had any problems with any of them. Here's a toll free number for a company that makes cams and regrinds
them too. The number is 1-800-248-0134,ext4204
and ask for Bob. The company is Wolverine Blue Racer and they sell performance cams. They make
genuine GM restoration parts camshafts for General Motors. I used one of their cams in an engine that I had to have bored oversize. I don't think you'll have any problems with a reground cam. I would use new valve springs.
Good Luck, Hal

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]