Farmall & IHC Tractors Discussion Board |
Re: distributor advance
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by rebuilder on October 06, 2004 at 04:38:39 from (66.228.102.32):
In Reply to: distributor advance posted by bob quale on October 05, 2004 at 17:41:05:
Bob Quale: The item you are refering to is called the cam. It should not have any play, however any play you do see is more likely from the driveshaft/bushing it rides on. You should have minimum play. Excess play will afect the point gap setting. You need to check the cam for wear on the cam surface where the point lever rides. If it looks scoured or wore then get a GOOD used one at a salvage yard. As far as lube, I make sure the bore is clean of debris with a drill bit and cloth then use lubriplate(rebuilder's grease) and don't forget the felt which goes into the open end of the cam. this should be oiled regularly.
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|