Farmall & IHC Tractors Discussion Board |
A 'C' 3pt conversion
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Zane(WA) on October 08, 2004 at 12:44:45 from (12.144.139.126):
I've acquired a 'C' that has a yellow 3-pt conversion and I'm curious whether the 3-pt is an IH OEM or an aftermarket manufacture. It has 2 flat bars connecting the Rock Shafts to the short upper lift arms, an adjustable 'top link' arrangement from each upper lift arm connecting to the lower lift arm on each side, giving it the ability to raise or lower each side independently. There is a 'normal' top link that mounts as on most tractors and an adjustable stabilizer to each lower lift arm. On the lower lift arms, in faded blue paint, is stenciled "IHxx" with xx being what appears to be two numerical digits (I can barely make out that they are numbers, what the numbers are is anyones guess). The ball ends of the lower lift arms will rotate for either a class 2 or class 3 hitch-up. Anyway, the unit as a whole is pretty stout, 1/2 inch plate lift arms, 3/8ths or 1/2 mounting frame (I don't know the Rockwell hardness of any of the metal). All the welds look to have good penetration and finsh (not ground or otherwise touched up) so I don't think this is a homemade unit. As I first mentioned, I'm just curious whether this is an OEM or some after-market unit. If it is after-market, what company may have made it? It works great, doesn't bind or bend when stressed, is fully adjustable and best of all it's a no-brainer for hook-up and adjustment. I would have posted a picture, but my daughter recently discovered that snow, rain and digital cameras are not a good combination.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|