Re: Oil blow bye on rebuilt motor

Posted by Allan in NE on October 10, 2004 at 07:05:45 from (148.78.243.25):

In Reply to: Oil blow bye on rebuilt motor posted by Bill from Seneca,IL on October 10, 2004 at 06:18:22:

Hi Bill,

Blow-by is nothing more than compression gases escaping around the rings. A certain amount is completely normal.

If it is excessive, I would suspect a ring (or rings) either being installed upside-down or not staggered right.

And again, like I have been harping to total excess here, if the engine was just rung and not rebuilt properly, there will always be too much blow-by....always; just can’t get around it.

In this case, there is just no way to ever seal up such an animal, save tearing it down and redoing it the right way.

Allan

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]