Farmall & IHC Tractors Discussion Board |
Re: 12 volt boost on 6 volt system
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on October 12, 2004 at 03:10:21 from (216.208.58.130):
In Reply to: 12 volt boost on 6 volt system posted by Belleville Neil on October 11, 2004 at 19:36:09:
Neil: If you are boosting from another vehicle using the idea your friend suggests, be careful nothing touches between vehicles. I was doing just that 35 years ago, and nice new steel cable attached to tractor fell on bumper of 63 Pontiac. The bang was much like a rifle shot and I had pieces of battery in a 50' radius. Luckily car was parked behind Farmall 300, and I was standing in front of tractor tire. The tire sheltered me from the acid spray. The only damage was a new battery for car and a lot of rusty hardware in surrounding area. Personally I would replace the battery cables with new 1 gauge cables with soldered on ends. You do that and with new 6 volt battery, if the W6 doesn't start at current temps, you have other things like points, condencer, rotor, cap, plugs or carb that need attention. I can see your need in getting tractor going to assist in diagnosis. Since 1939 the very best way to get a stubborn 4 cylinder gas IH going is a tow start. I have tinkered all day on these, nothing would make them start, not even 12 volts. Tow them 25 feet and they are going. I can remember a neighbor, hay and cattle farmer, had a fleet of about 6 H's, 300's, etc. When summer work was over he backed them in shed for winter. Come spring, he never even tried the starter, just hooked to them with his loader tractor that he used year around. Most of them started in shed doorway.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|