Re: 460 Trans bearing

Posted by captaink on October 20, 2004 at 07:29:29 from (66.115.214.56):

In Reply to: 460 Trans bearing posted by Spud on October 19, 2004 at 20:03:02:

Transmission is similar to an M or H except that output shaft from TA housing (has 5th gear center on shaft and countershaft drive gear on it) moves out with the split.

Not sure about parts, but if I were you while I was in there I’d check all the bearings especially the ones on the axles behind the bull gears. As a matter of fact, if you use the tractor a lot or plan to I’d replace the bearings behind the bull gears and use the old ones for paper weights on windy days. I’d replace as many bearings as my pocket book would allow IF this is a tractor I use a lot. If you use it only now and then, if the bearings rotate smoothly and quietly without clicking, you probably can get by putting them back in.

Check all the gears for flaking, chipped or broken (not rounded off) teeth and signs of metal going through them. Replace the springs and balls on the shift forks and check to make sure that the notches the shift lever goes into are nice and square. If not get the old welder around and square them up or get different ones.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]