|
Farmall & IHC Tractors Discussion Board |
Re: PTO Shaft Seal Interchange???
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on October 27, 2004 at 18:24:19 from (12.65.12.224):
In Reply to: Re: PTO Shaft Seal Interchange??? posted by Okie Dave on October 27, 2004 at 15:00:15:
The new seals are almost never the same as the originals. Improvements in seal technology have about gotten rid of the double thick seals except in cases of extreme service. All the letter series Farmalls are like that. You have a seal about an inch thick with two leather lip seals and maybe a felt wiper in there. You get a single lip seal for the new one. Some folks like to put in two of the new seals. I've never done than, only installing one of the new ones and have never had a problem. As long as the new seal fits the holder with the correct press fit and is the right diameter for the shaft you will be fine. Position the new seal in the holder so that it runs on a good part of the shaft where there are no grooves worn. You should be fine with what NAPA gave you.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Super Dexta - by Anthony West. The rusty blue tractor caught my eye as my truck zipped by the farm implement business. It looked so fornlorn amongst the lineup of newer equipment. But it was just the right size for my small farm. I stopped in and asked the proprietor for further information. "It's a 64 Ford Super Dexta", he said. "It's a tough little tractor, although it's a hard starter being a diesel and all." He did manage to get it running, compliments of a can of ether. Once started it putted along pretty good. It
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
