Farmall & IHC Tractors Discussion Board |
Re: Farmall 340-turn key and just snaps/clicks
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on November 21, 2004 at 07:08:08 from (69.201.120.79):
In Reply to: Farmall 340-turn key and just snaps/clicks posted by Al L. in Wisc. on November 21, 2004 at 03:12:16:
Al - In addition to the advice below check for the starter bendix jammed into the flywheel ring gear. (This happens a lot as the ring/bendix gears become badly worn.) Loosen the starter mounting bolts enough so you can pull the starter back and wiggle it around a bit, then retighten the bolts and try it. Or if your tractor is parked on hard ground put the transmission into road gear and manually rock the tractor back and forth until you see the fan blade move. Then try the starter again. If either of these fix the problem figure on replacing the bendix and/or ring gear for a permanent "cure"!
Follow Ups:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|