Farmall & IHC Tractors Discussion Board |
Re: 460 gas questions
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by captaink on December 20, 2004 at 12:50:41 from (66.115.214.56):
In Reply to: 460 gas questions posted by Bud in Pa on December 20, 2004 at 11:43:15:
It never hurts anything except your pocket book to change all the fluids and filters. That being said here are some suggestions if you want to hold down costs. The first thing I would do is change the engine oil now and after about 50 hours. Drain the anti-freeze and flush out the cooling system as best as possible (can take out the temperature sender and put in an adapter for a garden hose into it) and get new anti-freeze in it. After the tractor sets for a few days, loosen the drain plug on the back bottom of the rear end slowly and see if there is any water in it. The water will start to drip out just before the oil does, and the oil will start to drip out just before the plug comes out, so you will want to be careful when you do this. Change the hydraulic filter, and if the oil in the filter housing is “milky” in color, drop the rear-end/transmission oil and replace it with Hy-Tran. If you don’t find any water when you loosen the drain plug and the oil does not appear to be “milky” you can probably leave it in for a while unless you know it hasn’t been changed for a while. Depending on how it was used, 3255 hours can still be a good engine or it may be getting close to needing sleeves and pistons. If it uses a lot of oil (more than a quart a day) it will need to be rebuilt. Regardless, the rest of the tractor should be in excellent condition, as with decent care those rear ends would last at least 10,000 hrs. My nickels worth
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|