Re: Setting timing correctly on my 44 H

Posted by El Toro on December 31, 2004 at 15:30:49 from (170.224.224.154):

In Reply to: Setting timing correctly on my 44 H posted by tanner clark on December 31, 2004 at 14:13:07:

Hi Tanner, Why don't you use a timing light. Mark the knotch or groove on the pulley with a piece of chalk. Hook the timing light to the battery posts and the other lead to No1 sparkplug
that is closest to the radiator. My light is the inductive type that you just clip over the sparkplug wire. You may have a use piece of copper tubing to slide over the end of plug and hook the plug wire to the tubing, then hook timing light to tubing too. Run engine at an idle and switch on timing light. The light should blink every time the engine fires on No1. Note where chalk is on damper pulley. Should be close to pointer. You move distributor gently until both marks are aligned. Easier if you have a helper. Loosen distr. just enough so it can be
rotated if needed. Retighten when timing is set.
Hal

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]