Farmall & IHC Tractors Discussion Board |
Re: OT... Inverting an 18.4 34 tire
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Nebraska Cowman on January 05, 2005 at 15:32:05 from (65.162.146.104):
In Reply to: OT... Inverting an 18.4 34 tire posted by ButchWI on January 05, 2005 at 14:00:07:
ya, you could do one yourself. cut the bead off one side. Them you will have to figure some way to hold the tire solid. the guys that do it comercialy have a disk that fits inside the tire but big enough so it won't fit through the hole. then several hooks over the sidewall on the outside and pull real hard. just like skinning a muskrat. I'd think a guy could fasten the tire to a tree and then pull with a tracor. If there are guys in your area that would sure be the best. They will do it for about $5 if you take the tire to them where they are working.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|