Farmall & IHC Tractors Discussion Board |
Re: The Height of Ambition
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on January 19, 2005 at 14:56:56 from (64.228.11.36):
In Reply to: Re: The Height of Ambition posted by Allan in NE on January 19, 2005 at 11:49:42:
Allan: In my home town, we used to have tractor pulls, before the days of these automated sleds. Ours was a stone boat made from 4' x 10' sheet of 3/4 plate. We had boxes of sand, two sizes 200# and 100#, men put them on by hand and you had to start away with full load you chose. After each suceessful pull they would add more as you wished. The winner no matter how big or small was the tractor that could pull the highest percentage of it's weight with operator added in. The tractors to beat were Farmalls SA, H, SH and Cockshutt 30. They will all come in around 3 times their own weight. The M, SM big 6 cylinder Cockshutts and Olivers usually get stumped at around 2.75 to 2.8. of course we young teenagers at that time got regelated off to the little tractors. I've seen guys come there with big Cockshutts and Olivers, more weight added than SA or indeed even the H or 30 weighed. We've also seen a lot of disappointed age 30 something tractor drivers. Granted we teenagers did have more time to practice. It was a lot of fun. Then they started letting more than one guy pull the same tractor. That kind of ended tractor pulling. I remember my dad's H came home with the clutch toast, as did a few other tractors. The guys paying the bills suddenly decided we needed a less finincally demanding sport.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|