Farmall & IHC Tractors Discussion Board |
Re: Super C Questions.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by farmallhal on January 21, 2005 at 11:02:05 from (216.106.33.87):
In Reply to: Re: Super C Questions. posted by CNKS on January 21, 2005 at 09:57:47:
Thanks CNKS for your post and everything mentioned on this site is valuable. I am totally new to the C and Super C tractors. Just am looking to acquire one for a restoration project but want it to be correct. I just feel something is wrong with that S code engine block in a late 1951 SC where everything else is W coded. I have a restored H and M and everything is coded properly so I believe they are original tractors. Just can't get too excited about a tractor with the wrong engine block and don't know if it could even have the 123 cu. in. components anyway. Don't know if they used thinner wall sleeves to increase displacement or if they used a different block boring to accomodate standard wall sleeves. Just trying to pick up a "learning experience" from this venture. Didn't think of jotting down the block casting number until I was well on the way home. In looking at Guy Fay's "IH Tractor Data Book" it indicates the 123 cu. in. engine was only used in some 1954 Super A's and AV's and are designated in his book with a -1. So if his book is correct, and I have no reason to believe it isn't, the Super A series still had the 113 cu. in. engine until 1954. Don't know what the Super components might have been unless it was in the pistons or cylinder head as the Supers had a slightly higher compression ratio while retaining the same bore (3") and stroke (4"). I feel the tractor was truly a Super C as it had the usual identifying features, disc brakes, water pump, curved or dogleg pedals, etc.. Thanks again for your posts and I'll work through the threads that Stan sent along. Hal
Follow Ups:
Home
| Forums
Today's Featured Article -
The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|