|
Farmall & IHC Tractors Discussion Board |
1466 steering motor-darndest thing
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by SGT K on February 06, 2005 at 05:51:07 from (65.120.161.34):
Yesterday I pulled the 1466 out to get the planter out. I let it idle for about fifteen minutes, when I went to get back on it there was about a gallon of hydraulic oil pumped out of the steering motor. I pulled it up to the shop and took all of the tin work off. Sure enough, oil all over the steering motor. Checked the lines (all tight, couldn"t get that lucky) then I started it up to see where the oil was pouring out. Guess what, I couldn"t make it leak! I think the oil was comeing out of the top shaft seal, directly under the steering wheel. Anybody have this problem before? Can that seal leak, then seat back up again? Is it really a job getting the steering motor out? I"m not looking forward to this one :(
Thanks,
Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
