Farmall & IHC Tractors Discussion Board |
Farm Accident: Final Post
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on February 13, 2005 at 17:53:50 from (66.203.172.221):
For those who have been following my posts about our uncle's death on the farm I want to say thanks for your responses, your condolences and especially your sharing of similair stories. We need to remind each other of the daily dangers. Uncle Charlie made a mistake and we are all guilty of taking short cuts. He didn't put the pins in the bottom of the spear where it attaches to the loader. The weight of the bale would keep the spear in place until it was raised way up, crossing the yard he bounced in some ruts and the weight transferred over top dead center, releasing spear, bale and all down on top of him. He was 87 chronologically but he was 67 in mind and spirit. He had won many awards for his dairy herd over the years(Breed Production Average). When he went out of milking he just had to do something, so he got into the beef buisiness. He just bought a new GMC pick up, just had a pot load of cattle delivered, had just passed his Ontario Driver's Test that is mandatory for everyone over 85..he was looking forward ...So guys, put those shields in place, put the pins and clips in , check for wear and metal fatique, keep the loader low when moving and be carefull. Again, I think it is important for Farmallers to remind each other , through our stories and experiences so we aren't statistics. thanks everyone...Mike in Exeter Ontario
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|