Re: Pulling crankshaft

Posted by Ed H. on February 21, 2005 at 11:13:11 from (216.93.97.40):

In Reply to: Re: Pulling crankshaft posted by David Miller on February 21, 2005 at 09:18:40:

ofcourse not seeing it , its hard to say, but if the crank just has some marks on it but is still within the measured tolerance , it should be fine....i've had a few the same way.....use a micrometer to measure the rod journals, it will be diffacult to measure the main journals, ...but an expierenced eye can tell you if it looks damaged...get some emery paper and clean up the journals the best you can......when istalling the new bearings, obtain and learn how to use plasti-gauge, this will tell the whole story.......don't forget to hone the cylinder walls, and install new rings....and have the valves & seats ground in the head before installing it

Follow Ups:

Post a Followup Name: E-Mail: Hide: Yes No Hiding your address protects you from spam generators but allows you to receive email response notifications. Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]