Farmall & IHC Tractors Discussion Board |
Re: Engine Gunk (H)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John M on February 24, 2005 at 04:37:16 from (64.53.74.20):
In Reply to: Engine Gunk (H) posted by PurdueAg on February 23, 2005 at 20:07:14:
paleriders suggestion is what I have done more than once.Also remove the lifter cover and do that area as well.What I usually do is,after that first scrubbing,I fill it up to level with ever how many quarts it takes of non detergent minus one quart,replacing it with detergent oil,run it a littlew while and then chenge the oil with two quarts of detergent and so on and so on until I finally have all detergent oil in,changing the filter each time.It can get expensive doing that so I use cheapoer oil until I gettop the final stages,and if its not to awful bad inside I use the filter through two changes.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|