Re: 826 IH seal torque

Posted by K.B.-826 on March 16, 2005 at 21:37:39 from (68.115.88.96):

In Reply to: 826 IH seal torque posted by Todd in Sask. on March 16, 2005 at 20:07:14:

Yes, you need to split the tractor to replace the rear main seal. It also takes a special tool to set the seal at the correct depth. The tool can set the seal in three different 1/16 of an inch increments, so it wears on a different place of the crankshaft each time you replace it, so pay attention to where it is now. It definetly sounds like the TA is out. Sounds like a good time to do a complete TA job.

Follow Ups:

Post a Followup Name: E-Mail: Hide: Yes No Hiding your address protects you from spam generators but allows you to receive email response notifications. Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]